9.2.10 Data Sheet (965.2 kB 2008-08-20)

HRC-01 remote control

Application

• radio remote control of heliport/airport lighting equipment using the
• standard on-board transmitter
• switching-on FATO, TLOF, APP, PAPI, TWY, RWY lights
• switching-on wind cone illumination
• switching-on flash beacon

Certificate Basis

• ICAO Annex 14 Volume II Heliports
• FAA AC 150/5345-49C, L-854, Type I, 
• Air-to-Ground system
•  UCL (632.38 kB 2009-02-10)
•  LU SR (27.5 kB 2009-04-16)

Description/properties

• the lighting facility is operated from aircraft by clicking the microphone button (PTT) a specified number of times within a 5-second period as follows:
  - 3 clicks - lighting system energized on the low
  brightness step
  - 5 clicks - lighting system energized on the
  medium brightness step
  - 7 clicks - lighting system energized on the high
  brightness step
• each subsequent valid command will perform the required brightness step
• auto-off after 15 minutes from the last brightness step operation
• user adjustable operating frequency
• independent outdoor, omnidirectional antenna
• possible control and monitoring from a superior system (dry contact input or DAP 128TC transmission line)

Mechanical parameters

• dimensions 320 x 400 x 160 mm
• working temperature -20/+55 °C

HRC-01 parallel loop
• storage temperature  -20/+55 °C
• humidity max 95 %
• protection IP 54

Electrical parameters

• power supply    180–260 V / 47–63 Hz
• maximum input     30 W
• backup battery    12 V

HRC-01 serial loop

Receiver

• adjustable frequency range
  118–136 MHz
• antenna input impedance 50 Ω, conector RF Type N
• sensitivity 5 μV / 10 dB SINAD
• sensitivity 5 uV / 10 dB SINAD

Output remote control of attached device

• dry contact control max 20 m
• series communication line max 100 m

controlled only by HRC-01

Control and monitoring from a superior system

• dry contact control max 20 m
• communication line DAP 128TC max 10 km